What to do if you clogged the toilet

                                                        What to do if you clogged the toilet

Plumbing appliances tend to eventually become clogged. This is facilitated by the calcification is extremely hard water, urea and other sediment within the pipe and the narrow inner hole.But sometimes the clog will be provoked by the owners themselves. Most often this misfortune strikes the toilet, because people do not stop to flush down the toilet the leftover food, homemade fermented vegetables, like pickled tomatoes.And sometimes after cleaning the apartment with flushed dirty water, the rag accidentally “gets away.

 3 best options to solve relevant problems:

After such “feeding  the toilet refuses to work, blocking the passage of water in the pipe.And the owners have to choose: either to call a professional plumber, or look for ways on how to unclog the toilet on their own.We are going to analyze the best ways to struggle clogging by yourselves because the plumbers are not everywhere, and they are difficult to find.In order for the sewer pipes not to get overgrown with salt sediment, you should, at least once every three months, carry out a prevention technique.For this purpose, you can use any chemical agents that are designed for cleaning pipes. Pour the liquid according to the instructions at nighttime, when sanitary devices are not used.And then no sediment will have time to condense on the walls of pipes and to turn into stone, struggling with which is very difficult.Without preventive pouring of the chemicals your pipes will gradually overgrow with salt sediment and the water will stop flowing even without additional blockages. How to troubleshoot the complete coking of the system?The analysis of the degree of blockage and its possible causes:When choosing tools for cleaning the toilet, first find out the degree of blockage and, if possible, its cause. Water can trickle down slowly or not to pass at all. In order to figure it out you just need to pour about a liter of water in the toilet and see if it’s gone in half an hour.The tank should not be used to check up on the toilet, because when you press down on the toilet button all the available liquid (and it’s at least three liters!) will start flowing out. If the duct is packed tightly, water will begin to flow out on the floor of the toilet.Next, check just how much your blockage local.Turn on the faucet in the bathroom and in the kitchen and see what the situation is like with the sink.If the water is drained from both points in normal mode, then the clogged pipe is at the exit of the toilet bowl. It transports the liquid to the common sewer.If the flow is weak in all areas, then the problem is in the joint pipes, and it is necessary to apply more serious measures. The struggle with simple blockages:If the problem of the blockage is exclusive to the toilet, then in most cases use the mechanical method, chemicals and the punching with the plunger.

Option #1 — the mechanical method:

If toilet has got some object (a rag, Apple, etc.) in the descent, and the owners know the cause of the clog, the first thing we need do is to examine the origin of issue and the siphon.You will have to scoop out all the standing water in the bowl, put on a rubber glove on your hand and, if possible, cover the nose with a gauze bandage, because the smell will not be pleasant. You thrust the hand as deeply as possible into drain and figure out by touch whether any items in are still in the pipe. A rag or sponge easily can be pulled with your fingers, and if you got some kind of vegetable or fruit, then you can take it out with a hook with a bent wire on the end.  If the toilet is clogged an object or a rag, it is not necessary to purge it with air, otherwise you will pound the clog even further and you will not be able to get it out by yourself.

Option #2 — punching with a plunger:

If the cause of the blockage is unknown, but the water continues to drain slowly, you can try to break through the clog with a plunger. This device is owned by almost everyone, so it will not be difficult to find. Most importantly, the diameter of the rubber suction cup needs to be larger than the diameter of the drain hole.Traditional models have a wooden handle, but they are also available in a more modern design. This way you can remove the blockage that was formed in the siphon or a local pipe outlet drains into the joint sewage system.Under the pressure of the air and water the garbage clog will move deeper inside and will be released to a pipe with a larger diameter, and then it will freely float away from your home.In order for the punching to be most effective, it is necessary to close the hole for the lower and upper drain in the bathroom, the kitchen and then, with sharp jolts, pump the water in the toilet with a plunger. With a slow flow not only in the bathroom, but also in all the sinks, this procedure should be repeated in every plumbing fixture, while closing the remaining holes.(you close the toilet lid while you ask someone from the family to sit on its top). The size of the suction cup of the plunger must be larger than the drain hole of the toilet to hermetically close the area, because you will try to penetrate it.

Option # 3 – chemical control:

If the plunger still cannot be found, try to eat away at a clog, by using “chemicals” on it.The baking soda and vinegar are the simplest means, which are in every kitchen. They work as follows: Scoop out excess water, leaving a little bit in the drain.Pour half a pack of baking soda and push it as deep as possible. Pour a cup of vinegar. Wait until the end of the reaction (approximately 15-20 minutes).Pour a kettle of boiling water into the toilet bowl.Pouring boiling water is not recommended for toilets, where the connecting corrugation is made of thin plastic, because they may burst.In this case, you wash it with only hot water, not boiling water.Soda ash, diluted in water, instantly produces a chemical reaction if you splash some vinegar on it.As a result, many solid deposits in the pipes are destroyed.A more expensive option for chemical cleaning are special tools sold in stores, such as “Drain Opener”. They dissolve everything that had accumulated inside pipes (hair, limestone, salt, fat, etc.).But the maximum effect is worth the wait if the tubes are not too “overgrown”, and the deposits are in their initial stages.If the sediment had time to harden, then it will not be possible to punch through it with any chemicals.That is why it is recommended to regularly flush the sewers by special agents.How to troubleshoot the complete coking of the system? Now let’s see what can be done if you clogged the toilet completely, blocking the water flow.In this case, you buy or you ask your neighbors for special devices.Of all the things to clear the clog in the toilet, the most efficient and convenient one is considered a special sewer cable.It is quite flexible and has a metal sheath and a handle at the end.Flexible sewer cable can pass through curves of a drain and pipes, but needs help by making rotary movements of the handle.It is better to clean the pipe together, since the cable is advanced gradually and at the same time you can make rotational movements of the handle.It is necessary to rotate the cable in order to ensure that the cable could pass a bend in the pipe, which is made for blocking any unpleasant odors. While pushing the fixture to a maximum depth, it is necessary move them back and forth several times in order to stir up deposits on the tube walls.When you take the cable out after the procedure, put an old rag on the floor and immediately wipe the removed part with a cloth soaked in dish washing detergent. Otherwise, you will make a mess, and the floor will suffer as well. And the smell on your hands will be stay for a very long time.If you tried, as much as possible, to clear a blocked toilet, but it did not improve, then the problem may be with a common drain, through which the impurities are flushed from all apartments on the floors above.